drawer mould rack

Drawer Mold RackProduct Profile: Combined Structure,Simple and fast installation,improve the space utilization,the layer height at will adjustment,the lengh can be infinite outspread.Applicable to all kinds of molds and other materials placed. Exterior Dimensions:3100*600*2000(mm) Drawer Dimensions:900*600(mm) The layer load capacity:800 KG The cat block:one bearing and two wheels,load capacity 500 KG Assembly method: 1.First,link the upright and under frame.Second,assembly the above frame.Next step,check the between above frame and under frame spacing is the same(910mm). 2.The Front and rear slide rail installed on pillars at the top of the mold rack, adjust the balance and the middle spacing(550mm),place the cat block. 3.Move the drawer in the rails.The assembly direction is from back to front,pushed through the front bearing can be withheld,tighten the two sides insurance screw. 4.Instalation the back draw bar,check the diagonal dimensions must be same meanwhile tensioning draw bar. 5.Mold rack and the ground with the Φ12 iron expansion bolt fixed. 6.Disassembly and installation in the opposite direction. Using: Pull down the left swith can be put and take mold,just after take and put the mold,push the drawer utill swith automatically stop that place,mold placed should be from botton to top.Placed the first mold should be on safety and prevention tilt. Maintain: This equipment should be placed in dry and ventilated flat the ground, pulleys, rails should be regularly daub lubrication grease.